NO TE
The fingerprint and card reader with a key pad is connected to the access actuator by a network
cable.
Step 5 Check that cables are correctly connected.
Step 6 Secure the fingerprint and card reader with a keypad to the baseplate, as shown
by (5) and (6) in
----End
4.2.9.15 (Optional) Installing an In-Room Fingerprint and Card Reader
Context
●
The BOM number of a finger and card reader is 02070173.
●
It is recommended that the device be installed outside a room 1.4-1.6 m
above the floor
●
Do not install the product in a place with heavy dust or exposed to sunlight.
Procedure
Step 1 Remove the screws (set aside) from the fingerprint and card reader and take off
the baseplate, as shown by (1) in
.
Figure 4-171 Installing a fingerprint and card reader
Step 2 Mark the mounting holes using a marker, and drill holes using a hammer drill.
FusionModule800 Smart Small Data Center
User Manual
4 Installation Guide
Issue 01 (2021-02-05)
Copyright © Huawei Technologies Co., Ltd.
210