Procedure
Step 1 Remove the screw that secures the card reader with a keypad, and remove the
cable, as shown by (1), (2), and (3) in
Figure 6-80 Removing the bottom plate
Step 2 Remove the original bottom plate, as shown by (4) in
Step 3 Take out the bottom plate of the new card reader with a keypad and secure it.
Step 4 Connect the cable.
Step 5 Secure the card reader with a keypad to the bottom plate.
Step 6 Configure the new card reader with a keypad by following the instructions
provided in the document delivered with it.
Step 7 Choose Monitoring > System > ECC800 > Controls and delete the device failing
in communication.
Step 8 Refer to the section about commissioning the in-room access control system in the
installation guide and check that the fingerprint and card reader with a keypad
functions properly.
----End
Follow-up Procedure
Configure the new card reader with a keypad by following the instructions
provided in the document delivered with the ECC800-Pro.
6.4.4.23 Replacing an Emergency Door Release Button
Prerequisites
●
Recommended tool: Phillips screwdriver
●
An emergency door release button needs to be replaced.
●
A spare emergency door release button of the same model is available and
functional.
FusionModule800 Smart Small Data Center
User Manual
6 O&M
Issue 01 (2021-02-05)
Copyright © Huawei Technologies Co., Ltd.
486