l
If the log message indicating that a specific trap is generated does not exist on the host, the
trap is not generated. Go to Step 4.
l
If the log message indicating that a specific trap is generated exists on the host, the trap has
been generated, but the NMS fails to receive the trap message. Go to Step 4.
NOTE
The log message indicating that a specific trap is generated is as follows: #Jun 10 2010 09:55:03 Quideway
IFNET/2/IF_PVCDOWN:OID 1.3.6.1.6.3.1.1.5.3 Interface 109 turned into DOWN state.
Step 4
Collect the following information and contact Huawei technical support personnel:
l
Results of the preceding troubleshooting procedure
l
Configuration files, log files, and alarm files of the devices
----End
Relevant Alarms and Logs
Relevant Alarms
None.
Relevant Logs
None.
2.6 NQA Troubleshooting
2.6.1 A UDP Jitter Test Instance Fails to Be Started
Common Causes
This fault is commonly caused by one of the following:
l
The mandatory parameter of the test instance is incorrect.
Huawei AR2200-S Series Enterprise Routers
Troubleshooting
2 System
Issue 01 (2012-01-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31