4. Installation
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance may void the user’s
authority to operate the equipment.
Mount HY-RSD on the racking use hardware recommended by module racking vendor.
Recommend bolt size of 1/4 and torque no more than 76 in lbs.
If the HY-RSD is mounted at the back of a PV panel, installer shall follow PV module installation instructions.
The minimum distance between any portion of HY-RSD to the back of the PV panel shall be at least 0.5 in.
3. FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
BE AWARE THAT INSTALLATION OF THIS EQUIPMENT INCLUDES RISK OF ELECTRIC SHOCK.
NORMALLY GROUNDED CONDUCTORS MAY BE UNGROUNDED AND ENERGIZED WHEN A
GROUND FAULT IS INDICATED.
4.1 Attach HY-RSD to the Racking
Huayu(Ningbo)New Energy Technologies Co.,Ltd. All rights reserved.
c
03
