LXTB - Touch Tablet Graphical User Interface with Tablet Cradle
Installation Instructions
Hubbell Building Automation, Inc.
9601 Dessau Road • Building One • Suite 100
Austin, Texas 78754
512-450-1100 • 512-450-1215 Fax
www.hubbell-automation.com
Overview
This document provides instructions for the installation and operation of the Touch Tablet Graphical User Interface and Tablet Cradle.
Precautions
• Read and understand all instructions before beginning installation.
• Only use with provided 3’ RJ-45 cable.
• Only use with LX Lighting Control Panels mounted with Touch Tablet housing.
• For indoor use only.
• Notice: do not install or operate unit if any damage is noticed.
Installation
1. Install Tablet Cradle to Tablet Cradle Mounting Brackets using the 4 (four) screws included.
2. Plug 3’ RJ-45 cable (provided) into the RJ-45 socket located in back of the Touch Tablet.
3. Connect the Touch Tablet to the LX Lighting Control Panel by plugging the free end of the 3’ RJ-45 cable into the RJ-45 connector located
near the top of the Lighting Control Panel.
4. Once connected to the Lighting Control Panel, the Touch Tablet should automatically power up and be ready for use.
Tablet Cradle Mounting Brackets
Tablet Cradle
LXTB Tablet
Mounting Screws
(4 each)
Figure 1: Tablet Cradle Installation.
