Pub. 42004-541A
Hands-free VoIP Telephone Manual
Page 7 of 24
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-541A.docx
02/20
•
warm reset (internal command)
•
keypad error (if applicable)
•
key hook (off hook status, if applicable)
•
register fail (unsuccessful SIP registration)
•
audio path test (speaker/microphone test)
Status Indication
Power
The
ON
LED, located on the VoIP PCBA (see Figure 21 on Page 18), illuminates when power is applied
to the telephone.
Heartbeat
The
HB
LED, located on the VoIP PCBA (see Figure 21 on Page 18), flashes when communication over
the LAN is established.
Link
The
L
NK
LED, located on the VoIP PCBA (see Figure 21 on Page 18), indicates an active network
connection when illuminated.
Speed
The
SP
LED, located on the VoIP PCBA, (see Figure 21 on Page 18) indicates a 100 Mbps network
connection when illuminated or a10 Mbps connection when off.
VoIP Circuit PCBA Pushbuttons
Reset
Press the
RESET
button (see Figure 21 on Page 18) momentarily to warm reboot the telephone. The
telephone maintains the current configuration.
Factory
Use the
FACTORY
button (see Figure 21 on Page 18) to erase the current configuration and restore the
factory default settings as follows:
1.
Press and release the
RESET
button.
2.
Press and hold the FACTORY button for 10 seconds while the telephone is rebooting.
The telephone will reboot again with the factory default settings configured.
