System Configuration __________________________________________________________________
RF-MCGARDPRO
Hubbell Power Systems, Inc.
–
RFL™
Products
July 1, 2022
©2022 Hubbell Incorporated
4-47
5.
Front IP Address:
Displays the IP address of the front Ethernet port. This address is
programmed at the factory and cannot be changed.
6.
Front Netmask:
Displays the subnet mask of the front Ethernet port. The subnet mask
is programmed at the factory and cannot be changed.
7.
Front Gateway:
Displays the front gateway IP address for the corresponding Ethernet
port (factory set).
8.
Chassis Identification Number:
HPS/RFL
assigned number identifying the hardware
configuration. User changeable in case of hardware reconfiguration.
9.
Chassis Serial Number:
HPS/RFL
assigned serial number unique to an assembled
chassis. The Serial number can also be found on the side of the chassis. User changeable
in case of controller hardware being replaced.
4.14.2 System Settings
– Clock
Menu location: Configuration > System (Clock).
This web page is used to select the RTC (real time clock) and manipulate the date and time if
required. On boot-up the web page will display whatever the RTC is programmed to. The date
and time will be grayed out in the web page when an external clock source is synchronized.
Remember to click “Save” to make the changes permanent.
1
2
3
5
6
Select the date
or use “Today”
4
Figure 4-44. System Configuration, Clock
Note
: The status of the clock is displayed on the home page with the current system time.
1.
Date:
Displays the local date and time with offset from GMT.
2.
Date Setting Utility:
Can be set to a specific date, set to “Today” or cleared.
3.
Time:
Time display and setting field. To set the time use the gadget shown for each
field.
