Power Line Carrier ____________________________________________________________________
RF-MCGARDPRO
Hubbell Power Systems, Inc.
–
RFL™
Products
July 1, 2022
©2022 Hubbell Incorporated
5-31
On-Off Configuration
– Hard Carrier
Menu location: Configuration > PLC (HardCarrier).
1
2
Hard Carrier tab
3
Figure 5-14. On/Off Configuration, Hard Carrier
Hard Carrier Request:
1.
Request Number Code:
The code sent to the Remote end to request a hard carrier
response. The code can be sent using the following test page. Selections are 1-16 or Off.
Hard Carrier Response:
2.
Code:
A low or high-power response is sent if the selected code is received. Selections
are 1-16, or Off.
3.
Response Time:
Sets the duration of the hard carrier response. Can be set from 0 to 180
seconds in 1 second increments.
5.4.2.6.1 Recommended Hard Carrier Settings (Two Terminal)
RFL recommends the following settings for most standard PLC Hard Carrier Two-Terminal line
testing operations. Following the table below are the recommended settings for Three-Terminal
operation.
