Digital Communications Interfaces ________________________________________________________
RF-MCGARDPRO
Hubbell Power Systems, Inc.
–
RFL™
Products
July 1, 2022
©2022 Hubbell Incorporated
7-31
3.
Data Rate
: For G.703/64k this value will never be greater than 64 kbps.
If module is Disabled or Forced Disabled, field = “0”.
4.
Timing
: This value tells the user the timing setting of the interface.
Range: Internal (Bus n Master), Internal (Bus n Slave), Loop (Bus n Master)
If module is Disabled or Forced Disabled, field = “N/A”
5.
Tx Octet Timing
: This value tells the user the Tx Octet Timing status of the interface.
It is enabled or disabled. If module is Disabled or Forced Disabled, field = “N/A”
6.
Rx Octet Timing
: This value tells the user the Rx Octet Timing status of the interface.
It is enabled or disabled. If module is Disabled or Forced Disabled, field = “N/A”.
7.
Tx Activity
:
This is a status from the module of the Tx activity.
When healthy the value of this field is “OK”, in alarm the field reads “No Tx Activity”.
8.
Rx Activity
: This is a status from the module of Rx activity.
When healthy the value of this field is “OK”, in alarm the field reads “No Rx Activity”.
9.
Rx Alarm
: This is a status from the module indicating an Rx alarm.
When in alarm the field reads “Active”. With no alarm the field reads “None”.
10.
PLL Lock
: This is a status of the PLL lock. This indicates interface timing lock.
When not “Locked” the field reads “No”.
11.
Loopback
: This is a status of the loopback.
This field will never be in the ‘green’ state because it is disabled if Loopback is
Inactive.
12.
Reset All
: This button, when clicked, will reset the counters of the associated comms
interface.
Note
: Reset the following counters to zero by the “Reset All” button.
13.
Errored Seconds
: Provides a count of the total number of errored seconds since the last
reset.
14.
Errors per Second:
Provides a count of the number of errored words that occurred over
the last second.
