Digital Teleprotection __________________________________________________________________
RF-MCGARDPRO
Hubbell Power Systems, Inc.
–
RFL™
Products
July 1, 2022
©2022 Hubbell Incorporated
6-24
6.5.1 Digital Teleprotection - TSD Channel status
This page displays the status of the digital Teleprotection channel.
Digital Teleprotection (Slot 2)
–
Ch1
User Label
DTT
Ping-Pong (ms)
Frame OK
Tx Address
1
Rx Address
Mapped to
Slot 2 - c37.94
Bus / TS
Bus 1 / TS 3
Bit Error Rate
Errors per Second
0
Errored Seconds
26
OK
4
0.000 e+0
2 (expect 4)
Ch1 Status
Ch1 Functions
Figure 6-17. TSD - Digital Teleprotection, Channel selection
Alarms from channel status points listed underneath the heading are indicated by the color of
the page title.
•
Amber for module Minor Alarm
•
Red for module Major Alarm
All the information on this page is the same as described in section
. Fields which aren’t
directly equal are described below
•
Mapped to
: This field tells the user if the Teleprotection channel is mapped to a
communications interface (and if yes, which interface). The value here is taken from the
heading of the function table on the Status > Digital Teleprotection > Slot n – TPS
(Channel x) page. It is also available based on the programming in the Configuration >
Digital Comms > (Comms Interface) Timeslots Bus 1 & Bus 2 pages. If the channel is
not mapped it displays – “Not mapped”
•
Bus / timeslot:
This field tells the user what Bus and Timeslot the channel is mapped to,
if it is mapped. The value here is taken from the heading of the function table on the
Status > Digital Teleprotection > Slot n – TPS (Channel x) page. It is also available
based on the programming in the Configuration > Digital Comms > (Comms Interface)
Timeslots Bus 1 & Bus 2 pages.
