HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
3940 Dr. Martin Luther King Drive
St. Louis, Missouri 63113 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES SJIC and SJICH JUNCTION BOXES
Increased Safety Terminal Enclosures For Use In
Zone Classified Hazardous Locations
P/N KIL00921446 FORM NO. K1446 R6/18 ECO-2-045-18
Page 2 of
10
Application Information
a:
The enclosure forms the basis for certification of a unit or protection system for use in hazardous areas other than Zone 0 (Class I Div. 1).
b:
All internal components mounted in these Junction Box enclosures should be ATEX and IECEx Certified , and Listed or Recognized for CANADA and US, for
the application.
c:
All components must be installed in accordance with the component manufacturer's installation instructions.
d:
A complete Junction Box should be installed using supply wiring methods (including grounding) in accordance with the local/jurisdictional electrical
code(s).
Always Use Conductors with insulation rated 30
o
C greater than the marked ambient on the nameplate.
e.:
A 1/4-20 UNC (M6) ground / earthing stud is supplied on all Series SJICH and SJICH stainless steel enclosures.
f: T
o maintian proper IP ratings, be sure to follow all mfr's. mounting instructions when installing certified cable glands or conduit entries.
Warning: Enclosures must be installed in the upright vertical position only. Mounting the enclosures in a horizontal position could cause a fire or explosion due to
excessive dust / heat build-up
.
CATALOG LOGIC
SJIC * 12 12 06 W S 1 6 GP1234 *
_
1 2 3 4 5 6 7 8 9
1. SERIES
SJIC = Screw Cover
SJICH = Hinged Screw Cover
SPx = Customer Special Order Designator
2. MATERIAL
6 = 316 Stainless Steel
4 = 304 Stainless Steel
N = Non-metallic (Polymeric) Enclosure and Screw Cover –
Killark Series HKH Enclosures – available in SJIC style only (no hinges).
Blank = Carbon Steel (Painted)
3. ENCLOSURE SIZE - L x W x D (inches)
4. TERMINAL MANUFACTURER
W = Weidmuller
A = ABB
5. TERMINAL TYPE
S = Screw
C = Cage Clamp
6. NUMBER OF ROWS (OF TERMINALS)
7. TERMINAL BLOCK SIZE
1 = 1.5 mm
2
(#14 AWG) 2 = 2.5 mm
2
(#14 AWG)
4 = 4 mm
2
(#12 AWG) 6 = 6 mm
2
(#10 AWG)
10 = 10 mm
2
(#8 AWG) 16 = 16 mm
2
(#6 AWG)
35 = 35 mm
2
(#2 AWG)
For Larger Sizes : Please Contact Customer Service
8. GLAND PLATE LOCATOR
0 = None 1 = Bottom 2 = LHS 3 = Top 4 = RHS
9. OPTIONS (See Catalog)