13
Getting Started
English
2.4 Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedures below:
1. Press the button and the menu bar will pop up.
2. Press the
<
LEFT button or
>
RIGHT button until is highlighted, and
the - (delete) / + (add) / (view) / (scan) menu will pop up.
3. Press the
+
UP button or
-
DOWN button to (add), and press
the
button to confirm.
4. Camera
1
/
2
/
3
/
4
will pop up. Press the
+
UP button or
-
DOWN
button to select the desired Camera, and press the button to start
searching for a camera unit.
Note:
If a camera is currently paired with the Parent Unit, its camera
location (with a * beside it) cannot be selected for a new registration.
5. Press and hold the
PAIR
button on the bottom of the Baby Unit until
the Parent Unit finds the camera, beeps and
PAIR OK
appears on the
screen. The video from the camera will then appear.
Note
:
A camera can only be registered to one Parent Unit at any one time.
