9
4.3Battery Mounting
Notice:
>Do not mix old and new batteries
>Do not mix different types of batteries
>Do not charge non-rechargeable battery.
Open the cover
Take out the holder
According to the correct
polarities,install 8 x AA battery
4.3.5. ELEV SENSIVITY SET UP- EXPERT MODE
Hold down the ENT key for 1 second to enter the setting status, and then press the
DN key repeatedly until the five-point dotted line symbol starts to flash(see picture
below), press ELEVATOR TRIM key to idea sensitivity and then press EXT key for
2 seconds to confirm and exit.
4.3.6 AILE SENSIVITY SET UP- EXPERT MODE
Hold down the ENT key for 1 second to enter the setting status, and then press the
DN key repeatedly until the five-point dotted line symbol starts to flash, press
AILERON TRIM key to idea sensitivity and then press EXT key for 2 seconds to
confirm and exit.
5 Li-Po Battery Charging
10
Insert the plug into
Return the holder
Fasten the screw
the power jack back to the compartment
5.1 The helicopter is equipped with a LiPo battery:
7.4V 2 Cell 650mAh x 1 unit
5.2
Connect battery to balance charger and wall charger,The two led lights is red
whilst charging and turns green when charging is finished.
5.3.Please refer to 2.2. Safety Advisory Notice
Always partially charge your LiPo battery before storage. LiPo batteries retain a
charge over a reasonable period; It is not normally necessary to recharge stored LiPo
batteries unless stored for periods longer than 3-6 months.
If your LiPo battery has been over-discharged, it will not be possible to recharge it
again.
7.4V
