Hubsan H501S Advanced – Cheat Sheet
Settings Menu
Hold Enter button and pull throttle stick down
RSSI Mode
Hold down exit button and switch on transmitter
Circle fly
Hold down “Down” button for a long time. When you see ‘circle fly’ on the screen, let go of the
video button
Bind transmitter with quad
Hold down Enter button and power on transmitter
Manual Compass Calibration
Push the left stick to the most left side, and move the right stick left to right quickly until the
transmitter displays “Calibrate Compass 1”
Horizontal Calibration (IMU roll / pitch)
Push the left stick to the most right side, and move the right stick left to right quickly until the 4 LED
indicators blink yellow slowly. Calibration succeeded when the 4 LED indicators stop blinking slowly.
Rotational Calibration (use paper under the quad feet to allow smooth rotation)
Push the left stick to the top side, and move the right stick up and down quickly until the 4 LED
indicators blink in yellow slowly.
When the 4 LED indicator turns into red and blink circularly, rotate the quad horizontally clock-wise
until the 4 LEF indicators remain lighted in green.
When the 4 LED indicators turns into red again, rotate the quad horizontally clock-wise until the 4
LED indicators explosion-flashing simultaneously.
Recalibrating the Accelerometer
Quad on level surface, left stick to lower right, toggle right stick left and right until lights flash.
Transmitter Stick Calibration
Mode 2: Push both sticks to the upper left corner and power on the transmitter simultaneously, the
LCD will display “Calibrate Stick Mode 2”, rotate both sticks in circles for three times, release both
sticks, then press any trim for 1.5 seconds until one “beep” heard which indicates a successful
calibration.
