29
3. Uneven takeoff/unstable takeoff or flight
(1) Please keep the aircraft on a completely flat and stable surface after connecting it to power. Allow it to sit
still for at least 10 seconds before taking off (as to allow the gyro sensor to properly initialize).
(2) Place the aircraft on a completely flat and stable surface. Observe to see if the Roll (R) and Pitch (P)
telemetry values on the transmitter screen are 0. If they are not, please perform a horizontal/gyro calibration
for the aircraft.
4. The aircraft drifts badly in GPS Hold mode
(1) Check the surrounding area to see if there are any sources of GPS interference.
(2) Manually calibrate the compass.
5. The transmitter beeps
Check the transmitter’s power levels; please pause the flight to change and charge batteries.
6. When connected to power, the aircraft beeps incessantly
The flight control firmware needs to be reflashed appropriately.
7. There is no FPV
(1) Verify that the camera is powered on, the camera battery is sufficiently charged and that the camera is
properly connected to the aircraft.
(2) Rebind the aircraft to its transmitter.
8. The gimbal does not move or react
Make sure that the gimbal line is properly connected to the aircraft, especially after a crash. Always check the
state of the aircraft and its components after any kind of crash.
9. How to retrieve the aircraft when unit has been lost:
Record or take a picture of the aircraft’s GPS coordinates on the LCD screen. Then locate the aircraft using
the coordinates.
