©
2011 by Huchez Treuils S.A.S.
Translation of the original instructions manual
5
UK
Reproduction prohibited
The general periodic visits that involve an inspection of the state of preservation and the
operating tests.
The commissioning or recommissioning inspections in the event of a change in the place of use,
the configuration or the conditions of use on the same site; following the disassembly and
subsequent reassembly of the lifting machine; after any major replacement, repair or
transformation concerning the essential components of the lifting machine; following any
accident caused by the failure of an essential component of the lifting machine.
The maintenance booklet (order of 2nd March 2004 applicable from 1st
April 2005) which must
be used to record the maintenance operations carried out in accordance with the
recommendations of the manufacturer of the machine as well as any other inspection,
maintenance operation, repair, replacement or modification carried out on the machine. For
each operation, it is essential to record the date of the work, the names of the people and,
where appropriate, the companies which carried out the work, the nature of the operation and,
if it is a periodic operation, the frequency. If the operations involve the replacement of certain
components of the machine, the references of these components are indicated. The English
version of the maintenance booklet for our lifting winches can be downloaded from our website
www.huchez.fr/uk under the heading "After sales services”. A copy is however proposed in the
annexes of this manual.
The inspections must be carried out in accordance with a protocol and are intended to ensure
preventive maintenance aimed at detecting any damage or defect liable to cause a hazard.
6 – Presentation of the machines
6.1 - General
These winches are intended for pulling or lifting loads weighing a maximum of 250 to 1000 kg:
. Rigid stainless steel structure
. Mechanically welded stainless steel drum with wide flanges for safe and sound fastening of the rope.
. 230 volt with permanent capacitor – 50 Hz single-phase lifting-type self-braking motor. P = 0.75 kW or 1,1
kW according to the models – Class F – IP 66.
. 230/400 volt, 50 Hz three-phase lifting-type self-braking motor. P = 0.75 kW, 1,1 kW or 2,2 kW according
to the models – Class F – IP 66.
. Watertight reducer in oil bath with helical gears
. The FEM category is 1Bm (ISO : M3).
. Electrical equipment under watertight cover.
. Very low voltage, 24 V remote control
. 230 V single-phase or 230/400 V three-phase control box – IP 65 double insulation
. Emergency stop as standard
. The limit switch is standard and IP 66.
6.2 - Dimensions
