©
2014 by Huchez Treuils S.A.S.
Translation of the original instructions manual
14
EN
Reproduction prohibited
8.5.2. While using the PULLEY-MAN
Never detach the drill (or screwdriver) from the PULLEY-MAN during use: risk of a
sudden fall or movement of the load.
It is a good idea to take the following precautions:
Continuous operating time: 25 minutes.
For lifting operations:
-
To prevent the top of the load knocking into the bottom of the main body of the
PULLEY-MAN, maintain at least 30 cm between the bottom of the main body and the
rope hook.
-
Do not fix to a moving load.
-
Do not change the direction of the power supply abruptly.
-
Do not remain immediately below a suspended load or the PULLEY-MAN and keep out of
the way of the vertical line of a suspended load.
-
Make sure the loose rope does not get tangled up with the power cable.
-
Keep the loose rope away from the lifted load.
-
Do not walk on the loose rope.
-
Follow all other safety laws and regulations.
For pulling/haulage operations:
-
Check the rope is aligned in the pulley groove.
-
Do not leave any obstacle between the pulley and the load that puts the rope at an
angle. (This can wear or break the rope).
-
Check that no-one and nothing is in front of or behind the moving load.
-
Do not change the direction of the power supply abruptly.
-
Do not walk on the loose rope during use.
-
Make sure the loose rope does not get tangled with the power cable.
-
Keep the loose rope that has passed through the pulley away from the load to be
moved.
-
When the surface on which the load is being pulled is irregular or has hollows or holes,
use a plate to keep the route level.
Example: Where there is a gap, stairs or rising ground or when it is a load on a
mechanical tractor, etc.
-
When pulling a load on an inclined surface and when the load is unbalanced, take safety
measures to prevent the load slipping.
-
Do not halt operation when pulling a load on an inclined surface without taking control
or safety measures.
-
Do not fix to a moving load.
-
Follow all other applicable safety laws and regulations.
8.5.3. After using the PULLEY-MAN
You must make sure you:
Turn off the power supply.
Do not halt operation with a suspended load.
After use outside, tidy up everything in the area and put the PULLEY-MAN away in accordance
with the instructions in this manual.
Attention !
