18
Maintenance
Charging the Drive Battery
g g
y
Red
connector
Red battery
Connector
Charger
Connector
Red battery
connector
1
2
3
3
2
1
1. Ensure power switch is OFF
. Remove the
seat
(Refer to Seat Section) - use a
coin or screwdriver to unlock the
lock
in front middle of the seat.
2. Unplug
the
red battery connector
: Push the connectors fully together, then press
in the locking clip. Then pull connectors apart.
3. Plug
the
charger connector
into the
red battery connector
(Only use the 6V
charger included with the vehicle, input: AC 120V, 60Hz output: DC 6V), Plug the
charger into a standard 110V wall outlet.
4. After charging is complete (at least 8 hours, but not more than 12 hours)
5. Unplug the charger from the wall outlet.
6. Unplug
the
charger connector
from the
red battery connector
.
7. Reconnect
red connectors
.
8. Replace Seat (see Seat section).
CAUTION:
Ensure no wires or connectors are pinched under the seat when reinstall-
ing.
NOTE:
The charger may feel warm during the charging. This is normal and not a cause
for concern. If excessively hot, unplug and replace.
NOTE:
Before fi rst use, charge battery 15 to 18 hours.