9
Installing Steering Wheel, Power Supply and Seat
Assembly
3
10
15
16
Installation of steering wheel:
Installation of power supply, seat and backrest:
Car body hole
Plug
1
2
17
17
9
Battery black-plug (-)
Red
cable
Black cable
Driving
control board
5A over-current
protection
Battery
red-plug (+)
8
17
1
3
2
B
A
• Connect the steering wheel wire plug to the plug
extending out of the car body hole.
• Put the connected plugs and wires down into the car
body hole.
NOTE:
Ensure wires are not pinched our bound up.
• With J-shaped Steering Rod held in place, put the
steering wheel (part 3) onto the Steering Rod end,
and install the steering wheel screw (part 15) and
nut (part 16)
• Insert the forward/backward switch handle (part 10)
onto the shaft until it snaps in place.
• When battery is installed or replaced, insert
the Red cable terminal into the Red battery
positive pole and the Black terminal into the
Black battery negative pole.
• Connect Plug (
A
) to Connector (
B
) firmly.
WARNING:
Connecting incorrectly will
cause a short circuit.
Insert the backrest (part 8) into place as shown and
install the backrest screws (part 17) securely.
After the power supply is installed, put the seat (part
9) into the assigned location, and fix it with seat
screw (part 17).
