Continue to next section OVT TERMINAL ACTIVATION ON INSTALLER
OVT TERMINAL ACTIVATION ON INSTALLER PC
1. Once the HT1000 completes Registration, Ranging, and Association with the network, two links will
appear:
“On Site Validation” and “Terminal Activation”.
Note: You will also see “Waiting for Configuration” and an In-Progress” indicator. Ignore this line.
Continue on with next step. Configuration will continue in the background - no user action is required.
2.
Click “On Site Validation Tool”. You will automatically be directed to the Installation Portal.
3. Log into Consumer and Commercial Installation Portal using User Name and Password.
4. At Welcome Page, click "OnSite Validation Tool" link.
5. Enter SAN and FSO from Installation Reference Sheet and click "Submit".
6. Verify site information and e
nter antenna size and mount type and click “Proceed”.
7. System information including latest and target values being evaluated will be shown. If all values are
met, difference values are all green. Click "Sign Off" (If values are red, see below*).
8. Check box indicating "No Problem" and click" Save and Get Sign-off Code".
9. Record sign-off code on Installation Reference Sheet Click "Exit".
*If values are not met the difference values will appear in red. The OVT will display recommended
actions in the appropriate order helping you to troubleshoot the problem. For each recommended
action, one or two buttons are displayed. Click "Checked" if you checked the action and confirmed
that is not the issue Click "Repair" if you found any problem and completed the repair. The OVT will
update the latest values and recalculate the new difference values. Follow instructions until you obtain
a sign-off code.
10.
Close OVT window and click on “Registration” tab (a new window was opened for OVT, you are now
returning to previously opened registration tab).
11. Click
“Terminal Activation” link.
12.
Enter SAN and PIN and click “Continue”.
13. Verify customer details, confirm if correct.
14. When Terminal Activation Completed is completed a page will be displayed indicating the Terminal
Activation was successful, that the modem will update with the latest software, and then reboot. The
whole process takes about 5 minutes.
15.
Go to the System Status page and monitor Software Download Status. When it says “Up To Date”
proceed to the next step.
SERVICE ACTIVATION
1. Disconnect your laptop and connect the satellite modem to customers PC and have the customer
perform Service Activation by following steps below.
2. Enter
www.systemcontrolcenter.com
in URL field and press enter.
3.
Click “Service Activation” Link. If Service Activation link is not visible on main page of SCC then
installer may have to wait up to several minutes to appear.
4.
Customer clicks “I accept the Terms & Conditions” and clicks “Continue".
5. Account Registration page is displayed
with a “Register” link. The customer will need to Click
“Register” and provide an existing email address or establish a new Hughes email address. Click
“Continue”.
6. Screen will show completing service activation and will, when complete, display the
“myhughesnet.com” home page. Customer can now browse the internet. (This step may a few
minutes to complete.)
