Before you assemble the antenna, read these important instructions:
•
Sequence of steps – When you assemble the antenna,
be sure to follow the
instructions in this chapter in the order they are presented.
For rooftop installations, assemble the antenna on the ground and then carry
the fully assembled antenna up to the roof.
•
Tightening hardware –
Do not tighten any nuts or other hardware until
instructed to do so.
See
Table 4
for torque specifications.
•
Torque – To ensure successful installation of the antenna, it is critical you
tighten all nuts and socket-head screws to the torque values shown in
Table 4
.
Table 4: Torque specifications
Fastener or connector
Proper torque value
5
/
16
inch bolts
8 ft-lb
1
/
4
inch bolts
5 ft-lb
IFL cable connectors for connections to the radio
and ground block
20 inch-lb
Select the installation site
Before selecting an antenna installation site, check OASIS or the installation
reference sheet to see if there is a customer preference for the installation site.
Work with the customer to see if a line of sight (LOS) is available at their preferred
site. Refer to the appropriate antenna site preparation and mount installation guide
that discusses the factors you should consider when selecting an installation site.
The first and most important consideration when choosing a prospective site is
whether the area can provide an acceptable LOS to the satellite. Choose a site
where the antenna will be able to receive the strongest signal available. A clear,
unobstructed view of the southern sky is necessary for proper transmission.
Consider obstructions that may occur in the future, such as construction in the area,
or the growth of trees.
Also, consider potential grounding sources when choosing a location. For guidance
on grounding, see the documents listed in
Ground connections
on page 38.
As with any type of construction, a local building permit may be required before
installing the antenna. It is the property owner's responsibility to obtain necessary
permits and comply with local building codes.
22
Chapter 3 • Installing the antenna and radio
1039384-0001 Revision C