Chapter 2 • DW7700 component and feature descriptions
12
1036332-0001 Revision C
Dual Ethernet ports
The DW7700 has two RJ-45, 10/100BaseT Ethernet ports as
shown in Figure 6. Each port has a green and a yellow LED. A
flashing green LED indicates a valid link between the DW7700
and Ethernet device; a dark LED indicates an invalid link. An
illuminated yellow LED indicates the port is operating in
100BaseT mode; a dark yellow LED indicates the port is
operating in 10BaseT mode.
The ports support a wide range of devices, including:
•
PCs equipped with Network Interface Cards (NICs)
•
DIRECWAY Serial Appliance, which can support up to four
serial devices
•
Hubs
•
Routers
•
Switches
Ethernet port configurations
The Ethernet ports support the following configurations:
•
Dual port, single subnet
Only one Ethernet port is configured with an IP address at the
NOC, which means the terminal supports one subnet and
functions as a hub.
•
Dual port, independent subnet
Each Ethernet port is configured with a separate IP address at
the NOC, which means the terminal supports independent
subnets and functions as a router.
Figure 6: Dual Ethernet ports
Summary of Contents for DiRECWAY DW7700
