Please read this entire document before attempting your first installation. If you are unsure of any part of
this procedure contact our technical support team for further advice.
1.
Equipment Preparation
The Hughes 9000 series modems are integrated receive and transmit units with single LAN interface.
Power specification of these ODUs is 1 Watt.
IF cables: RG6 type for transmission and reception, two separate cables are required. It is important that
the right quality cable is used in order to achieve the right signal levels depending on the cable length
(attenuation). Please review the table attached in
Appendix B
at the back of this document.
You need a valid configuration sheet for the site for the site to be commissioned. Ensure you have this
before attending site. This contains details of IP addresses, satellite parameters and other settings that are
needed for your modem to function.
Ensure your antenna is installed and accurately aligned before you start to configure the modem.
(From LNB)
(From BUC)
