Select the VSAT Manual commissioning page.
These are
NOT to be
used…
This window allows you to change the Satellite parameters, VSAT Lats & Longs, IP/LAN parameters & network
management parameters. All the information required to complete this stage is on your site-specific
configuration sheet, with the exception of the RFU part number (get this directly from your RFU) & the VSAT
Lats & Longs (your local GPS).
Double check all parameters before selecting “
Save Configuration
”,
the modem will reset.
When the unit restarts, browse back to:
http://192.168.0.1/
and then click ‘System Status’
Then take note of the signal strength, (The modem RX LED should now be lit).