17 /
18
www.huion.com
6. CE and FCC Notice
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 0mm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device should
not contain any metallic components. Body-worn accessories that do not meet
these requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
This device in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. All essential radio test suites have been carried
out.
1. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS:
2.The product shall only be connected to a USB interface of version USB 2.0
3. The device complies with RF specifications when the device used at 0mm form
your body
This device complies with part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interferenceChanges or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits
aredesigned to provide reasonable protection against harmful interference in
aresidential installation. This equipment generates, uses and can radiate
radiofrequency energy and, if not installed and used in accordance with
theinstructions, may cause harmful interference to radio communications.
However,there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user
isencouraged to try to correct the interference by one or more of the
followingmeasures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit differentfrom that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician forhelp.
Specific Absorption Rate (SAR) information:
This device meets the government's requirements for exposure to radio waves. The
guidelines are based on standards that were developed by independent scientific
