16
8.5 The electronics.
The Pendel uses 2 electronic systems. One special controller for controlling the drive
motor, and one system for the additional electric functions of the Pendel.
8.5.1 Sevcon drive controller.
The drive controller is controlling the drive motor of the Pendel. The controller is a
microprocessor controlled device. All driving characteristics are programmed in this
controller. Driving characteristic can be adapted to the requirements of the user. The
controller can be programmed using a special handheld programmer or using an interface
connected to a PC. Parameters like maximum forward speed, maximum reverse speed,
acceleration, etc. can be programmed and changed.
Programming the Pendel drive controller is only to be done by staff of
Huka BV or authorized and trained persons of an authorized huka
dealer.
Programming done by unauthorized persons can lead to dangerous
situations and is therefore strictly forbidden.
Errors in the programming of the Pendel FD can lead to material
damage to the Pendel or even personal damage to the user and/or
persons who are close to the Pendel.
After changing a parameter of the drive controller, there should be a
test drive first to check if the programming is done properly. If the test
drive was successful and save, the Pendel will be returned to its user.
Adjusting parameters outside the specified limits might lead to
strange drive behavior of the Pendel FD. This could result in personal
or material damage.
Summary of Contents for Pendel FD
Page 1: ...1 User manual P Pe en nd de el l F FD D 2011 01...
Page 44: ...44 Notes...