28
8.7.11 Release switch
The release switch is used to lower the Pendel for transferring in and out of the Pendel. To
lower the Pendel, push the lever down. You will hear air escape from the suspension and
the Pendel will lower itself to the ground. Before lifting the Pendel, you must put the lever
back to the top position.
8.8 Fixation points
The manual wheelchair is locked inside the Pendel by two parts: the fixation points and the
rear ramp. Depending on the size of the wheel of the, manual wheelchair the fixation
points can be adjusted.
How to adjust the fixation point is explained in chapter 9.2
Be sure to put the lever back into the upper position before you lift the
Pendel in to its driving position. If the lever is still in the lower
position, it is not possible to lift the Pendel.
Be sure the area around the rear wheels and the ramp is cleared and
no objects are in that area which might block the Pendel from moving
down. During the lowering there might be a danger of pinching of
body parts or objects are in this area.
Summary of Contents for Pendel FD
Page 1: ...1 User manual P Pe en nd de el l F FD D 2011 01...
Page 44: ...44 Notes...