30
9. Before using the Pendel FD
Before you use the Pendel FD for the first time you must adjust some settings.
9.1 Adjusting the handle bar.
The height of the handle bar:
- 1. Release the bolt (A) with an Allan key size 6 mm until the handlebar can be moved.
- 2. Move the handle bar into the right height.
- 3. Tighten the bolt
The angle of the handle bar:
- 1. Release the bolt (B) with an Allan key size 6 mm until the handlebar can be moved.
- 2. Move the handle bar into the right angle.
- 3. Tighten the bolt
Make sure the bolts are tightened correctly before driving the Pendel.
If the handle bar is not tightened well enough, it might move whilst
driving. This can result in a dangerous situation.
A
B
Summary of Contents for Pendel FD
Page 1: ...1 User manual P Pe en nd de el l F FD D 2011 01...
Page 44: ...44 Notes...