Hultafors H3x360G, Operating Instructions Manual

15

ca. 10 m

A

B

ca.

20 cm

180°

ca. 10 m

180°

4

1

A

B

A

ca.

20 cm

B

3

1

d 1

4

2

3

1

2

2

d 2

•  Mark the center point of  

 and  

.

•  If the reference points 

 and 

 are on 

different sides of the  
  center point, 

 must be subtracted 

from 

.

•   If the reference points 

 and 

 are on the 

same side of the  
center point, 

 must be added to 

.

•  Divide the results with twice the value of the 

room length.

If the result is greater than 4 mm, the device 
must be readjusted. For this, please consult your 
dealer.

9. Maintenance, storage and 

transportation

9.1 Cleaning

•  Wipe off any dirt with a soft damp cloth.
•  Check the outlet openings of the laser regularly, 

and thoroughly clean them if necessary. Do not 
touch the glass with your fingers.

•  Do not use aggressive cleaning agents or 

solvents.

•  Do not immerse the device into water!
•  Clean and dry wet equipment, accessories 

and transport containers prior to packaging 
them. Only pack equipment again when it is 
completely dry.

•  Keep plug connections clean and protected 

from moisture.

9.2 Storage

9.2.1 GENERAL

•  The equipment may only be stored within the 

specified temperature limits  

(see Chapter 3 / Technical data).

•  After a prolonged storage, check the accuracy 

of the measuring device before using it.

9.2.2 BATTERIES 

•  For storage, remove the batteries from the 

device or from the charging station.

•  The storage should preferably be performed in 

a dry environment at room temperature 

(see Chapter 3 / Technical data).