15
2.
Press the “M” button once to switch on the meter.
After a short “beep” a full display will appear on screen,
and the meter enters standby mode.
3.
Press the “M” button once again and the meter will
switch to memory mode. The 7-day average (7 DAY.A)
will be displayed on the screen.
4.
Repeated pressing of the “M” button will switch to the
14, 21 and 28-day averages.
5.
After the 28-day average, the stored results appear
on the screen, starting with M01. The memory number
increases by one each time the button is pressed until
M360 is reached.
6.
Press the “Set” button for over 3 seconds and the meter
will switch off after a long “beep”. The meter will also auto-
matically shut down after max. 3 minutes without any input.
Note:
>
If 360 test results are already stored and a new one
is added, the oldest test result is automatically over-
written. The latest result will be recorded as M01.
The performance of test strips may be affected by im-
proper storage and handling. Please store the test strips
and meter carefully according to the specifications listed
in Chapter 8.
Note:
1.
Store the meter, code strip, test strips and control
solution at 10…30°C.
2.
Do not store test strips in a high humidity environ-
ment or expose them to direct sunlight.
3.
Do not freeze or refrigerate the meter or strips.
4.
Keep the meter clean by wiping the exterior with a
tissue or a lint-free cloth.
5.
Handle the strip with clean, dry hands; the skin penetra-
tion site for the blood sample should be cleaned and dried
thoroughly.
Chapter 5 Storage & Handling
Chapter 4 Meter Memory Function
