50 English
Connection jack for vibrating pillow and/or modules
Your telephone is equipped with a connection jack for a vibrating pillow or other additional
signaling modules. You can take advantage of this option to signal an incoming call not only
with a very loud ring and the very bright flashing light, but also with an optionally available
vibrating pillow and/ or other module.
The following optional modules can be connected to the telephone:
- Vibrating pillow
- Flash module
- Switch module
- Acoustic module
Headset port
Standard headset port with a 2.5 mm jack.
Headphone port
3.5mm output for connecting headphones, an induction loop or such like.
Setting the telephone to the default settings
1. Press
. „Set Display” will be shown in the display.
2. Enter 0,4,2,2,0,0,0,1,1 over the keypad
3. Press
. You hear a signal tone.
4. Disconnect the small PSU plug from the DC connection jack at the backside of the tele-
phone.
5. Please wait three seconds and reconnect the small PSU plug with the DC connection
jack.
6. The telephone is set to the default settings now.
Default settings:
One-touch dial keys:
Empty
Redial memory:
Empty
Calling number display memory (CLIP):
Empty
Telephone book:
Empty
Recall time:
300 ms
Dialing mode:
Tone
Ring tone:
2
Keypad tones:
Switched on
Volume:
Level 4
Resetting the telephone to the factory settings
Additional ports
Summary of Contents for FLASHTEL COMFORT 3 BT
Page 106: ...106 ...
Page 107: ...107 ...