Humanware SmartView nano User Manual Download

Page: 7 / 7

3.2 Recharging the Battery
The SmartView Nano uses 3 AAA NI-MH

rechargeable batteries. To recharge the

SmartView Nano:

•

Connect the charger to one end of the

USB cable.

•

Connect the other end of the USB

connector to the SmartView Nano's USB

port.

•

Plug the charger to an electrical outlet.

The SmartView Nano needs to be plugged

in for approximately 3 hours to reach full

charge.

Once fully charged, the SmartView Nano

can be used for a period of about 3 hours.

3.3 Installing lanyard
To install lanyard, turn the SmartView

Nano upside down and open the battery

compartment. Insert string around both

sides of the opening above the USB jack.

Close battery compartment.

Summary of Contents for SmartView nano





