Support devices
79
Chassis
4
Supports
–
Supports are used to support your trailer when loading
and unloading as well as when parking.
–
From a load-capacity point of view, supports are not
designed to lift a trailer.
–
Supports protect your trailer from damage caused when
loading and unloading.
–
There are many different types of support available,
depending on the load to be supported and operation of
the supports.
–
Variants:
Prop stands, telescopic crank supports,
Folding supports, corner legs
Only carry out retrospective installation in
designated attachment points.
Read and observe the assembly instructions.
CAUTION
Operating the supports!
It is possible to crush your feet / hands under the supports
between the chassis and the supports.
Use .
When lowering the supports, keep your feet out
of the danger zone.
WARNING
Supports not in driving position before setting off!
Supports could come loose or be ripped away when driving
along.
Before setting off, ensure the supports are in driving
position.
Secure the supports against falling down.
WARNING
Parking the trailer with supports on uneven / soft
ground!
If on a slope, the supports could sink in/ break off while
loading / unloading.
Place the trailer on solid, level ground.
If the ground is soft, (e.g. gravel, sand), place firm
supports under the support legs.
WARNING
Loss of stability when driving onto the trailer!
A redistribution of weight caused by driving onto the trailer
or uneven ground can cause the trailer to sink on one side.
The trailer could tip over and the load could slip off.
Lower the support legs before loading / unloading.
NOTICE
Overloading the support legs when loading!
The support legs have been lowered all the way to the
ground and are bearing the entire weight of the trailer and
the load. The support legs can be damaged.
When loading, only lower the support legs until there is
4-6 cm clearance from the ground.
Fig. 20
Support for loading
1
Clearance / gap
The trailer suspension gives slightly when loaded and is
stabilised by the support legs.
Fig. 21
Support for unloading
2
Ground
The suspension on the trailer has given slightly under the
load and is stabilised by the supports. When unloading, the
weight is taken off the supports.
F - 088
1
1
F - 089
2
2
Summary of Contents for 1000 Series
