Loading ramps
95
Chassis
4
Using ramps
–
Ramps such as: Drive-up ramps / tracks, ramp walls
make loading and unloading easier.
–
Ramps are designed to be suitable for the type of trailer
depending on the load.
–
Ramps are not designed for point loads.
You will find how to use loading ramps in the
operating manual for your type of trailer Part 2.
Driving on the loading ramps with e.g. Pallet trucks
or cherry pickers is not permitted - these cause a
point load which is too high due to their small
wheels.
WARNING
Overloading ramps!
Driving on the ramps may cause a loss of stability and may
break them.
They could fall off during the loading / unloading process -
risk of being knocked / crushed!
Do not put more weight on the ramps than the max.
permitted - see load data on the label in the operating
instructions Part 2 for the respective type of trailer.
Before loading, ensure that the maximum carrying
capacity is not exceeded by the load / vehicle to be
loaded.
Do not drive with a deformed ramp - replace any faulty
ramps immediately.
Fig. 73
Safety during operation
1
Supports
2
Loading ramp
3
Edge of cargo bed
Requirements:
–
Supports (Fig. 73 /1) are positioned to provide support -
stability is ensured.
–
Ramps, e.g. track ramps / drive-up ramps (Fig. 73 /2)
are positioned at the track width of the vehicle to be
loaded.
–
Ramps are secured against sliding off the edge of the
cargo bed (Fig. 73 /3).
–
Drive-up angle does not exceed the 30% incline
(max. 16.5°).
CAUTION
Operating ramps!
When lowering / folding down / positioning the
ramps, you can crush your hands / fingers / feet
between the ground and the ramp.
When closing the ramps, you could crush your
fingers / hands between the stanchions / wall edge
and ramp.
Use , .
Fold down / lower the ramps in a controlled way - do not
allow them to fall down.
Stand to one side when folding down / positioning the
ramps – not in the area where you could be injured.
Keep your distance.
Make sure that your feet are not under the ramps.
F - 070
1
2
3
Summary of Contents for 1000 Series
