Operating Instruction Manual HKT (Part 2)
Version
2019/01
17
►
►
Ensure that the tailgate is secured with the gas strut lock.
►
►
Turn the snap-locks upwards on both sides.
- The bolts will move out of their locking brackets.
►
►
Hold onto the side of the ramp door and carefully
lower it.
Closing the ramp door
Locking the ramp door
►
►
Hold onto the side of the ramp door and carefully raise it.
►
►
Turn the snap-locks downwards.
- The bolts will move into their locking brackets.
- The ramp door is locked into place.
Closing the tailgate
Gas strut locked
unlocked
►
►
Turn the piston retainer by 180°.
The
piston retainer
is unlocked.
Locking the tailgate
►
►
Hold the tailgate and step behind it (to the rear of the
trailer).
►
►
Use both your hands to push down the tailgate.
- Ensure that the espagnolette lock is open and that the
locking cams engage smoothly.
►
►
Pull up the bolt handle and then push it in firmly.
- The bolt handle will automatically lock into the pressure
protection mechanism.
►
►
Where necessary, use a key to secure the safety lock.
6.8 Loading the trailer
Make sure that the trailer is secured so
that it cannot roll away.
►
►
Make sure that road traffic safety is not impaired
when loading and unloading the trailer.
►
►
If necessary, use additional signalling devices,
e.g. signs, barriers.
Stepping onto the cargo bed!
You could fall off if you step onto the cargo bed
during the loading and unloading process.
►
►
Take particular care when stepping onto the cargo bed.
►
►
Use
.
Loading a motorcycle
►
►
Carefully push the motorcycle onto the trailer until the
front wheel is inside the motorcycle stand.
-
Observe the section: 6.1 Load distribution
Tying down / securing a motorcycle
►
►
Tie down / secure the motorcycle in a standing position.
- Observe the section:
6.2 Load securing
Lifting / securing the cargo bed
►
►
Lift the cargo bed.
►
►
Secure it, using the safety lock.
- Observe the section:
6.8 Lifting the cargo bed
WARNING
