OREION™ HUMMER HX-T™ OWNERS MANUAL
18
4. Inspect and clean battery wires. Damage or frayed wires should be replaced by a qualified
technician.
5. Store the cart in a cool, dry location.
6. Adjust the tire pressure to the recommended levels – 30 psi.
7. Lubricate front and rear suspension lubrication points – the lubrication nipples can be
found on the suspension arms.
Returning Cart to Service
1. Fully charge the batteries.
2. Check battery electrolyte levels, add distilled water if necessary after charging.
3. Adjust the tire pressure to the recommended levels.
4. Perform Pre-operation Checklist (see page 15).
Maintenance:
•
Only a certified technician should repair the cart. It is important to abide by all
procedures described in this manual and all safety signs such as “Danger”, “Warning”, or
“Caution”.
•
If a problem is found during routine maintenance or inspection, do not operate the cart
until the problem has been repaired.
•
Wear proper safety apparel while repairing the cart. Proper safety apparel includes but
is not limited to: safety goggles or approved eye protection, insulated gloves, and a face
mask.
•
Remove all jewellery and loose apparel items.
•
Use insulated tools while working on any electrical components.
•
Set the key switch to OFF and the drive stick to Park (‘P’). Use chocks to secure the
wheels.
•
Components such as the motor, controller, and resistor may become hot during
operation. To avoid burns, allow these components time to cool before a certified
technician performs service or inspects the cart.
WARNING
