4. Assemble flange, bolt, and gasket, then place over ½” hole. Secure in place with #8 x 5/8 flat
head screws.
5. Position the GPS receiver with cable through hole, then secure in place.
6. Connect extension cable to GPS receiver cable.
No Access Under Mounting Location GPS receiver routing the cable to the side.
1. Determine the best location, then route the 20 foot extension cable from control head to
mounting location.
2. Place flange over mounting location and mark through the three mounting holes for drilling.
3. Remove flange and drill holes using a 9/64” drill bit.
4. Break out the marked tab on the bottom side, outer rim of the flange.
5. Preassemble the flange, mounting bolt, and gasket with the GPS receiver, routing cable
through all components; tighten GPS receiver until its base is in contact with the gasket.
6. Secure flange with #8 x 5/8 flat head screws. To access all screws you will need to rotate the
GPS receiver. When finished, secure tightly.
7. Determine a hole location where access for cable routing is available.
8. Drill a ½” hole at this location and route the cable through the hole.
9. Install escutcheon plate at this location with #8 x 5/8 flat head screws.
