Place against hull
Align with transom.
DO NOT LET DEADRISE
INTERSECT THIS LINE
PLACE EITHER CORNER
ON DEADRISE ANGLE
TOP
Use 5/32" drill bit
Drill
Drill
PLACE EITHER CORNER
ON DEADRISE ANGLE
TOP
Use 5/32" drill bit
Drill
Drill
Level
15", 380mm
from prop(s)
Cut along this line for fiberglass hulls
Aluminum
Tr
ansducer
Guide
¹⁄₂
"
bas du transducteur
Hull
Cut along this line for aluminum hulls
Fibre de verre
This reference square
should measure 2" x 2" when
printed.
Set your Page Setup % in your
Printer utility to either enlarge
more or reduce the printed
template if adjustment is needed.
2"
Remove and use for
Transducer Installation
PLACE EITHER CORNER
ON DEADRISE
TOP
Use
⁵⁄₃₂
" (4.0mm) drill bit
Drill
Drill
Use with XT ser
ies
T
ransducers
Fiberglass
Alumium
Drill a set of two holes for your type of
boat hull. Use the upper set for fiberglass
or the lower set for aluminum.
5
Adobe Acrobat has several ways to control the
output size of a document.
In "Page Setup" set your sheet size to the size
of sheet used and Scale to 100%.
Under Print, pick the options for "Adobe Acrobat
(Version Number)" i.e. Acrobat 5.0 and DESE-
LECT
•"Shrink Oversize Pages to Paper Size"
•"Enlarge Small Pages to Paper Size".
If your printed template does not match the 2"
size requirement, increase your percentage set-
ting if it is less than 2", decrease your percent-
age setting if it is greater than 2".
If you wish to calculate the needed percentage
divide 2 by the measured size. Use this result
as a percentage for your "Page Setup".
Example:
Measured size = 1 13/16"
2 ÷ (1 + (13 ÷ 16)) = 1.103 or 110%
or
2 ÷ 1.8125 = 1.103 or 110%
Set your Page Setup scale to 110%
Windows Sample Print Menu
Macintosh Sample Print Menu
