9
Configuring Network Parameters
Purpose:
If you don’t know the IP address of the decoder and this is not the first time you use the decoder, you can use
SADP (IP finder) software or the Serial port tools to find out the IP address of the decoder and to configure the IP
address or other network parameters of it. It is recommended to change the default IP address for the first time to
use it.
This chapter aims to tell the procedures of using the SADP software to find and configure the IP address and other
parameters of the device.
Note:
For the first-time user, the default user name of HER503Series is
admin
, and password is
12345
. And the default
IP address is 192.0.0.64.
Searching Online Devices
z
Searching online devices automatically
Click
to run the SADP software and it will automatically search the online devices every 15
seconds from the subnet where your computer locates. It displays the total number and information of the searched
devices in the
Online Devices
interface. Device information including the device type, IP address, port number,
gateway, etc. will be displayed.
Note:
Device can be searched and displayed in the list in 15 seconds after it goes online; it will be removed from
