50
Wireless Setting
(Optional, support 802.11 b/g/n)
For setting up the IP camera via wireless network, first, use the Ethernet cable
to connect the camera.
After finishing & saving the wireless settings, remove the Ethernet cable.
Note:
The IP address is the same under both wireless and wired network. If the
Ethernet cable is plugged in the camera, the IP camera will use it to link to the
Internet instead of the wireless router.
Status of Networks in Wireless Setting
The camera scans and shows the SSID, Mode, Security, and Signal strength of
the wireless network.
Mode:
Infrastructure
mode is used to link to the wireless router.
Ad-hoc
mode is used to link to the PC directly.
Domain
and
Channel
options appear only in the Ad-hoc mode.
Ad-hoc
i
s a short term derived from
wireless ad hoc network
, known as
WANET
. This type of network is only established temporarily, and does not rely
on a pre-existing network through a router or Wireless Access Point.
