INSTALLATION
9
STEP 3 — Connect the Power Source
NOTE:
When power is connected to the motor, a green LED inside the manual control button
housing will flash to indicate the shade is ready for operation.
■
Refer to the appropriate page below based on your order.
➤
For a battery wand, see below.
➤
For a satellite battery pack, see page 10.
➤
For an 18V DC power supply, see page 11.
➤
For an 18V DC power supply with daisy-chain connections, see page 12.
➤
For a C-size satellite battery wand or large DC power supply, see the instructions that
came with the unit.
If You Have a Battery Wand...
Install Batteries Into the Battery Wand
NOTE:
Hunter Douglas recommends AA alkaline batteries for use with our battery-powered
shades. These will provide more than one year of operation, depending on usage. Lithium and
rechargeable batteries are not recommended.
■
Squeeze the cap latch to release and
remove the cap.
■
Install the batteries according to the
instructions on the battery wand label.
■
Replace the cap.
➤
Align the tab with the end of the wand.
➤
Press the cap on until it latches.
Mount the Battery Wand into the Battery Wand Clips
■
Align the battery wand with its socket toward the motor side end cap.
■
Push the battery wand straight up into the battery wand clip until it snaps into place. Check
to make sure the battery wand is secure.
CAUTION:
Be sure the cable does not become pinched by the installation bracket or
battery wand clip. Damage or overheating of components could result.
Back of Shade
Socket
Tab
Battery
Wand
Squeeze
Cap Latch
Slot
