INSTALLATION
6
■
Drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Attach the installation or extension brackets using the screws provided.
IMPORTANT:
The front edges of the brackets must be level and aligned to each other.
■
When using spacer blocks:
If necessary, first attach the installation bracket to a
1
/
2
"
spacer block as shown on page 3.
➤
Additional
1
/
8
" and
1
/
2
" spacer blocks may
be stacked together up to the recommended
maximum of 1
1
/
2
".
➤
Attach the spacer blocks/installation brackets
to a flat vertical mounting surface with
#6 mounting screws long enough for a secure
installation.
IMPORTANT:
Spacer blocks are recommended
to project the installation brackets away from the
mounting surface for rear fabric fold clearance.
Add
3
/
4
" for standard Vignette
®
Tiered
™
or 1"
for Vignette Tiered Architella
®
. (With shades
using a battery wand, an absolute minimum
of
3
/
4
" added clearance is required.)
■
If using extension brackets, attach an installation
bracket to the underside of each extension bracket
using the provided screws and speed nuts.
Proceed to “STEP 2 — Install the Shade” on page 8.
Speed Nut
Screw
Spacer
Blocks
Longer
Screw
