7
Removing Internal Components
All internal components must be removed prior to fitting the stove. This will make handling the stove
easier; allow access to fixings and the flue outlet; as well as protect the internal components from
damage during the installation process.
1.
To open the stove door, pull on the door lever to release it from the magnet.
N.B When closing the door keep the door handle out to the right until the door is closed.
N.B from this point forward, the door has been hidden for illustrative purposes.
2.
Remove the log retainer by lifting it clear of the two support pins.
3.
Remove the baffle brick (Eco R4/Eco R5 by lifting it up, sliding it to the right and then lowering the
left-hand edge into the firebox. For the Eco R6 slide both baffle plates to the centre with left hand
baffle on top of right-hand baffle and lift out of stove together.
Eco R4/R5
Eco R6
4.
Remove the two side bricks by lifting them up to release them from the slots in the base brick.
Swing the bricks into the centre and remove them from the stove.
