Assembly Instructions
PLEASE READ THESE INSTRUCTIONS CAREFULLY
It is important that your stove is correctly installed, as Hunter Stoves Limited cannot
accept responsibility for any fault arising through incorrect use or installation.
Important Warning
This stove must not be installed into a chimney that serves any other heating appliance.
There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit
fumes into the room.
Flue Collar
Place the Flue Gasket on the top or rear outlet as required. Place the Flue Collar on top of the Gasket.
Secure to the four locating tabs, inside the flue outlet, using the M6 nuts & bolts supplied. Fit the 2 - M8
carriage bolts, washers & nuts into the Damper Holes, located on each side of the Flue Collar.
Flue Cover
Fit the Flue Gasket and Blanking Plate on the remaining free outlet and secure
it, using 2 - M6 screws.
