13
JINTDI05 Rev E 20/04/54
9.
Unscrew the two M6 screws and remove the
Turbo Bars.
10.
Remove the lower side bricks by tilting the
top edge of the Bricks into the firebox and
lifting out.
11.
Remove the lower rear brick by tilting the top
edge into the firebox and lifting out.
12.
Remove the side grate bars by lifting them
away from the cam bar and pulling forward
out of the rear support.
N.B. When re-installing, the side bars need
to be installed first, followed by the singular
bars. The final two grate bars should be
installed at the same time for ease of fit.
13.
Remove the cam bar by firstly sliding it to the
right until the left hand end is clear of the
hole.
14.
Then maneuver the left end of the cam bar
into the void in the front left hand side of the
stove.
15.
Then raise the right hand side and swing out
through the door opening.
