17
41457-01 7/2000
®
2. Make wiring connections using
the wire nuts supplied. To con-
nect the wires, place bare metal
leads together. Place a wire nut
over the intertwined length of
wire and twist clockwise until
tight as shown. Refer to Figure
6d.
Figure 6e - Positioning the Receiver
Inside of the Canopy
3. Place receiver inside the canopy
under the ceiling plate. Refer to
Figure 6e. Be sure to keep the
antenna positioned securely on
top of the receiver. Do not modify
or damage the antenna wire, as
control performance may be re-
duced.
Connect .............................................................................................................. To
Green wire from fan .................................................................... Bare ground wire
Black wire from receiver .............................................................. Black supply wire
White wire from receiver ............................................................ White supply wire
White wire from receiver ......................................................... White wire from fan
Black wire from receiver ........................................................... Black wire from fan
Black/White wire from receiver .................................... Black/White wire from light
Once receiver is installed and
power is turned back on, DO
NOT pull the fan or light chains
while power is connected.
WARNING
Ceiling
Plate
Antenna
Receiver
Canopy
Figure 6d - Wiring the Receiver
Black/
White
Black
Black
White
White
White
Black
Black/
White
AC
Power
In
Antenna
Note:
For optimal performance,
the antenna should extend out-
side the canopy.
4. Continue to STEP 8, HANGING
THE FAN, on page 20.
Summary of Contents for 41457-01
Page 2: ...2 41457 01 7 2000 ...
