Hunter 42015-01, Installating And Operation Manual

8

Hunter Fan Company 

42015-01 • 02/15/05 

9

42015-01 • 02/15/05 

Hunter Fan Company

5 • Wiring the Fan

All wiring must be in accordance with national and local electrical 
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a 
qualified electrician.

5-1.  Disconnect the power by turning off the circuit breakers to the 

outlet box and associated wall switch location.

5-2.  To connect the wires, hold the bare metal leads together and place 

a wire nut over them, then twist clockwise until tight. For all these 
connections use the larger wire nuts provided.

CAUTION:

  Be sure no bare wire or wire strands are visible after 

making connections.

5-3.  Connect the ground wire from the ceiling to the green ground 

wire from the hanger bracket and the green ground wire from the 
downrod.

5-4.  Connect the white and black wires from the ceiling as follows::

• e white (common) power wire from the ceiling to the white 

wire from the receiver (marked on red tag “NEUTRAL IN”) 

• e black power wire from the ceiling to the black wire from 

the receiver (marked on red tag “LIVE IN”)

5-5.  Connect the wires from the fan as follows:

• e black/white wire from the fan to the red wire from the 

receiver (marked on white tag “LIGHT OUT”)

• e black wire from the fan to the black wire from the receiver 

(marked on white tag “FAN OUT”)

• e white wire from the fan to the white wire from the receiver 

(marked on white tag “COMMON OUT”)

5-6.  Push all wires and wire nuts back through the hanger bracket hole 

into the outlet box.

5-7.  Run the white antenna wire from the receiver through one of the 

slots in the hanger bracket so that it rests between the hanger 
bracket and the ceiling. Push it to the edge of the hanger bracket 
for clear reception.

Wire Nut

Steps 5-3 – 5-7

Antenna