Hunter 7 Models, Owner'S Manual And Installation Manual

11

42768-01  •  02/23/09  •  Hunter Fan Company

Attaching the Upper Switch Housing 

7-5.  Remove the four upper switch housing screws holding the steel shipping 

bumper onto the bottom of the fan. Save the screws and discard the 

shipping bumper.

7-6.  Feed the upper plug connector through the center hole in the upper 

switch housing.

7-7.  Align  the  holes  in  the  upper  switch  housing  with  the  spokes  in  the 

mounting plate.

7-8.  Insert and tighten the four upper switch housing screws into the outermost 

holes in the upper switch housing.

 CAUTION: 

Make sure the upper switch housing is securely attached 

to the switch housing mounting plate. Failure to properly attach and 
tighten all four housing assembly screws could result in water entry 
into live connection area and/or the switch housing and light fixture 
falling.

 Attaching the Lower Switch Housing/Light Kit Assembly

7-9.  Locate the lower switch housing screws.

 NOTE:

  Depending upon your fan model, these screws may be installed 

in the four spokes from the switch housing mounting plate, or they may 

be located in the sack parts.

7-10.  Partially install the lower switch housing screws into the spokes from the 

switch housing mounting plate.

NOTE: 

 If these screws came installed, make sure that they are partially 

installed in order to complete the following steps.

7-11.  Connect the upper plug connector to the lower plug connector from the 

lower switch housing assembly.

 NOTE: 

Both plug connectors are polarized and will only fit together 

one way. Make sure that both connectors are properly aligned before 

connecting them together. Incorrect connection could cause improper 

operation and damage to the product. 

7-12.  Align the keyhole slots in the lower switch housing with the upper switch 

housing screws that were installed in Step 7-7.

7-13.  Turn the lower switch housing clockwise until the corners of the lower 

switch housing align with the corners of the motor housing. If the corners 

do not align on the first attempt, turn the lower switch housing to line 

one keyhole slot up with the next screw to either side and try again.

7-14.  Tighten all lower switch housing assembly screws. 

7 • Completing Your Installation With a Light Fixture (Continued)

Step 7-5

Step 7-7

Upper 

Switch 

Housing 

Screws

Spokes

Motor 

Housing

Lower 

Switch 

Housing 

Screw

Keyhole 

Slots

Lower 

Switch 

Housing

Corners

Lower Switch 

Housing Screws