7
1886
1886
Installing the Glass
Installing the Blades:
Installing the Upper Switch Housing
Repeat x3
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the
hardware bag.
Fit
th
e c
an
op
y in
pla
ce as s
hown.
bag
Canopy Screw
x9
bag
Blade Screw
x9
bag
Blade Washer
Insert the blade into the blade slot. Put the
blade washers found in the hardware
bag onto the blade screws found in the
hardware bag. Then install the blade
screws to secure each blade to the fan.
Installing the Light Fixture
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
1 of 7
Light Kit Screw
bag
2 of 7
Light Kit Screw
bag
1
STEP
2
STEP
3
STEP
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Glass/Bulbs
Fan style may vary.
Note:
