www.HunterFanInternational.com
Remote Control
Within 3 minutes
of restoring power
to the fan, press both the Fan Off
button and the High button for at
least 4 seconds. Your fan will turn on
low to indicate successful syncing.
If it does not, turn off power to your
fan, wait 1 minute then try again. If
using the transmitter with multiple
fans, repeat this process for each fan.
Note:
The remote must be paired
before the fan will operate.
Fan Off
High
Rocker- Style
Plate
Switch Cover
Plate
Removed
Tabs
To install the transmitter cradle, remove
the two screws holding the switch
cover plate. Do not remove the cover
plate. Orient the cradle by lining up
the two mounting holes with those on
the cover plate. Insert and tighten the
screws. Do not over tighten.
Note:
For rocker-style cover plates,
break off the tabs by pushing outward.
To turn on fan, press a fan speed
button. Speeds range from off (0)
to high (3). Quickly press the Light
button to turn the lights off and on.
Medium
Speed
Light
High
Speed
Fan
Off
Low
Speed
ON
Turn Power
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. The battery
should be installed with the positive
(+) side up. Replace with a CR2032
battery when necessary.
Phillips
Head
Screw
Battery
Door
13
MB502-01 • 03/25/14 •
© Hunter Fan Company
